ASME B107.2:2002 pdf download

ASME B107.2:2002 pdf download SOCKET WRENCHES, EXTENSIONS, ADAPTORS, AND UNIVERSAL JOINTS (INNI SERIES) POWER DRIVE QMPAD
1 SCOPE
This Standard is intended to cover the complete general and dimensional data for detachable socket wrenches, extensions, adaptors, and universal jints for power drive impact use. Inclusion of dimensional data in this Standard is not intended to imply that ail of the products described herein are stock production sizes. Consumers are requested to consult with manufacturers concerning lists of stock production sizes. All dimensions in this Standard are in inches.
2 CLASSIFICATION
Type I: Sockets, single (6-point) and double
(12-point) hexagon
Class I: Regular length
Class 2: Long length
Class 3: Extra long length
Class 4: Regular length, thin wall
Class 5: Long length, thin wall
Type II: Sockets, single square (4-point) and
double square (8-point)
Class I: Regular length
Class 2: Long length
point) and double hexagon (1 2-point)
Class 1: Regular length
Class 2: Long length
Type IV: Bars, extension
Type V: Adaptors
Type VI: Universal joint
Type VII: Sockets, #5 Spline Drive
Type m: Universal sockets, single hexagon (6-
Class I: Regular length
Class 2: Long length
3 NORMATIVE REFERENCES
The following documents form a part of this Standard to the extent specified herein. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this Standard are encouraged to investigate the possibil-ity of applying the most recent edition of the documentsindicated below.
ASME B107.4M-1995，Driving and Spindle Ends forPortable Hand,Impact，Air and Electric Tools (per-cussion tools excluded)
ASME B107.17M-1997,Gages,Wrench Openings, Ref-erence
Publisher: The American Society of Mechanical Engi-neers (ASME International),Three Park Avenue,New York,NY 10016-5990;Order Department: 22Law Drive,PO Box 2300，Fairfield,NJ07007-2300ASTM E 18-97a，Standard Test Methods for RockwellHardness and Rockwell Superficial Hardness of Me-tallic Materials
Publisher: American Society for Testing and Materials(ASTM)，100 Barr Harbor Drive,West Consho-hocken，PA 19428-2959
4 REQUIREMENTS
4.1 lllustrations
The illustrations shown herein are descriptive andnot restrictive,and are not intended to preclude themanufacture of sockets and attachments that are other-wise in accordance with this Standard.
4.2 Materials
Unless otherwise specified, the material used in thetools shall be steel, the chemical composition and heattreatment of which shall be such as to produce toolsconforming to the requirements hereinafter specified.
4.3 Dimensions
Dimensions shall be in accordance with applicabletables.